Home Improvement Stack Exchange
Home Improvement Stack Exchange

Questions tagged [ledger]

50 questions
4
votes
2 answers

Can beams be up against a post base like this?

I'm building a 12x16 ground-level deck in my backyard (not attached to the house). I'll have 4x6 beams anchored to concrete footing. My question is: can I install a 4x6 ledger beam that will have its ends up against a post base (the beam will be…
pixelgecko
  • 41
  • 1
3
votes
1 answer

How can I improve this deck ledger and the flashing around my ledger?

I'm planning to replace the current warped ledger board with a new one new using galvanized lag bolts. How can I protect the exposed black paper and OSB between the two vents? Is more flashing needed on the bottom of the ledger? Any other tips?
Shawn H
  • 247
  • 2
  • 3
  • 7
3
votes
2 answers

Attaching ledger board to brick and block wall?

I'm building an enclosed 1 floor addition on the side of our house which will extend our side entry to become a mudroom and provide for a pantry off our kitchen. We need the space under the addition to be open for various reasons, so are using a…
Dave
  • 31
  • 1
3
votes
2 answers

Reinforcement for Ledger Board on Bearing Wall

I'm helping a friend remodel an old addition on his house. We've uncovered a construction technique that may have been normal 60 years ago, but isn't up to the standards of today. I'd like to know if there is a simple remedy. We are looking at a…
Doug Hill
  • 339
  • 5
  • 12
2
votes
1 answer

Can I attach a freestanding deck to concrete block garage wall?

I'm certain you can't attach a ledger to cinder block that is why the deck is going to be free standing. However, I would like to know if the deck could somehow be secured to the garage. Kind of like what a ledger board does only without joist…
Mrall
  • 21
  • 3
2
votes
2 answers

Floor joist attachment improvements in presence of existing ledger?

TL;DR: AFAIK there are no joist hangers that can be retrofit in a location where there's an existing ledger board without removing said ledger, right? Is there anything I should think about aside from adding blocking between joists, given the…
Andrew Sullivan
  • 81
  • 7
2
votes
2 answers

How to attach ledger board to under-roof siding?

I want to attach a ledger board, over the existing wood siding. Something similar to this, but immediately underneath the roof How do I determine where I need to drill the holes to attach it to the siding - basically, how do I find the joists? An…
funtastic
  • 143
  • 4
  • 6
  • 11
2
votes
1 answer

What should I do on the sides of a deck ledger?

I plan on hanging my ledger board similar to the picture described here. I am going to be bending coil stock for the drip cap and the Z flashing. The diagram though doesn't depict what should be done for the sides of the ledger against the J…
maple_shaft
  • 3,192
  • 8
  • 33
  • 48
2
votes
0 answers

Failing 2x4 "ledger" board

My deck is currently failing due to the fact that it is supported by 2x4 boards nailed into what is either a double plate below the floor joists or the end grain of the joists themselves, there is no band joist. The deck joists are just sitting on…
Andrew M
  • 21
  • 1
2
votes
0 answers

How can I replace a pergola ledger that's right under-roof?

I was thinking about replacing my older deck/pergola. I’m planning to do a similar build of the existing deck and feel somewhat confident with the framing and posts. However, I could use some guidance with the pergola ledger. Context: I’m a new…
Breuer
  • 21
  • 2
2
votes
1 answer

How should I hang joists that are supposed to be doubled, but that will sit over the joining of two boards?

I need to hang a 22' ledger board, but I can only get treated boards up to 20' in length. The deck plan calls for a doubled joist at the 18' mark, which is where the edge of the main body of the deck meets the upper stair landing (a 4x4 landing). …
DonBoitnott
  • 597
  • 2
  • 7
  • 22
2
votes
3 answers

Deck ledger flashing options

I am having an existing deck/porch that is attached to my home repaired/replaced due to termite and water damage. I told the guys to replace any damaged wood they thought necessary. The replaced the ledger, but after the fact I realize there should…
eaglerockdude
  • 59
  • 6
2
votes
1 answer

Is it okay if my ledger board overlaps my foundation wall?

I just got done demoing a 20yo deck that had no footings or flashing. It was constructed of 2x8's on a 2x10 beam cantilevered. So, my design was to be all 2x10's with a flush beam because the deck is not high off the ground, there is a lot of…
jmichas
  • 123
  • 4
2
votes
2 answers

Deck stairs pulling apart and railing wobbly

My deck stairs which are supported by ledger strips keep pulling away the stringer. Last year I used a clamp to squeeze them back together but they pulled away again. The railing also is wobbly. What would be the best way to fix the stairs so…
Marc
  • 51
  • 1
  • 4
2
votes
0 answers

How to attach a deck ledger board to a house with no rim joist

We are building a deck, and the whole time so far we have been planning on attaching the deck to the house via a ledger board. After stripping the siding and insulation foam board, we discovered that all that remains is ~7/8" sheathing attached to…
dcstraw
  • 121
  • 3
1
2 3 4